Computerised Francis Turbine Trainer

The closed water circuit consists of a tank with optional cooling, a centrifugal pump and a flow control valve for adjusting the inlet pressure.
The transparent operating area of the turbine enables an optimal view of water flow, rotor and guide vanes during operation.
By adjusting the guide vanes the angle of attack, the cross-section and thus the output of the turbine are changed.
An asynchronous machine is used as a generator for loading the turbine.
A pump with variable speed via frequency converter provides for an energy efficient operation.
The speed of the turbine is recorded by means of an inductive, non-contact position sensor at the generator shaft.
The generator is equipped with a pendulum bearing and with a force sensor to determine the torque.
The pressures at the inlet and outlet of the turbine, the temperature and the flow rate are recorded by sensors.
The measured values are displayed digitally and can be processed further on a PC.
FEATURES:
Determination of the mechanical power and hydraulic power of the turbine
Determination of efficiency
Recording of characteristic curves
Investigation of the conversion of hydraulic into mechanical energy
Investigation of the influence of the guide vane position
Velocity triangles
SPECIFICATIONS:
Hydraulic power: 2,1kW at 1500min-1
Mechanical power: approx. 1,4kW at 1500min-1
Rotor, D: 165mm, 8 blades
8 guide vanes, angle of attack adjustable: 0…23°
Centrifugal pump, multistage :
Variable speed
Power consumption: 5,5kW
Max. Flow rate: 900L/min
Pump head: 42m
Asynchronous machine as generator :
Output: 2,2kW at 1440min-1
Tank: 550L
Measuring ranges :
Temperature: 0…100°C
Flow rate: 0…1000L/min
Torque: 0…20Nm
Speed: 0…3000min-1
Pressure (inlet): ±1bar (turbine)
Pressure (outlet): 0…6bar (turbine)
Power: 0…2200W (generator)
400V, 50Hz, 3 phases
400V, 60Hz, 3 phases, 230V, 60Hz, 3 phases